This mod took me quite some time, though you wouldn't say that. With my advanced fan controller(link) combined with a rheobus and all that mesh, bolts and nuts it wasn't done a job that I could finish quickly.
I noticed you need to insulate the fans well when hooking them up to a rheobus as they'll start to vibrate really badly. The enermax fans on top aren't insulated yet so they make lots of noise. To compensate I hooked them up to my fan bus. The best way to kill the vibration noise with case fans is to use some rubber washers between the case and fan. And making sure you screw them very tight!
As usual, I've ran all out of cash so I couldn't buy rather expensive stuff like noise-isolation and decent 120mm fans :). I'll add more LED's when I've got the time, more advanced isolation of the noise will have to follow later on.
The final result pleases me: good looking, quite well performing and cheap. No window so I don't have to worry about scratches and a cleaned up inside of the case. The LEDs used or not those that lighten up the entire room annoying everybody, but rather more discreet and cool looking
Del med dine venner